More JSON.mkd

[apps/agl-service-can-low-level.git] / JSON.mkd

diff --git a/JSON.mkd b/JSON.mkd
index 4656ca3..72860cb 100644 (file)
--- a/JSON.mkd
+++ b/JSON.mkd
@@ -368,7 +368,7 @@ the "Signals Defined from Diagnostic Messages" section below.
 
 **Response**
 
-f the predefined requests were enabled or disabled successfully, the `status` in
+If the predefined requests were enabled or disabled successfully, the `status` in
 the response will be `true`.
 
     { "command_response": "predefined_obd2", "status": true}
@@ -377,11 +377,11 @@ the response will be `true`.
 
 The ModemConfigurationCommand message allows users to change certain aspects of modem operation on-the-fly (at runtime). The modem configuration settings are stored in flash memory and are untouched by the bootloader during a software update (assuming the correct cellular_c5 linker file is used during compilation of vi-firmware). Thus, new modem settings persistent across power cycles.
 
-The ModemConfigurationCommand message provides three sub-messages for particular groups of modem settings. These are NetworkOperatorSettings, NetworkDataSettings, and ServerConnectSettings. These configuration messages are described in great detail within the cellular_c5_config documentation. 
+The ModemConfigurationCommand message provides three sub-messages for particular groups of modem settings. These are NetworkOperatorSettings, NetworkDataSettings, and ServerConnectSettings. These configuration messages are described in great detail within the [cellular_c5_config](vi-firmware/docs/advanced/cellular_c5_config.mkd) documentation. 
 
 Currently, only the ServerConnectSettings sub-message is supported in the vi-firmware's command interpreter. All other settings are currently compile-time only.
 
-The ServerConnectSettings command allows the user to set the host server name and port that the device will use when opening a TCP socket to upload data. This destination must be running an HTTP server similar to OpenXCWebServer, which defines a set of supported HTTP transactions where the body carries data to/from the device in the familiar OpenXC Message Format.
+The ServerConnectSettings part of ModemConfigurationCommand allows the user to set the host server name and port that the device will use when opening a TCP socket to upload data. This destination must be running an HTTP server similar to OpenXCWebServer, which defines a set of supported HTTP transactions where the body is comprised of data in the familiar OpenXC Message Format.
 
 **Request**