+For a Porter board, you'll have your CAN device as `can1` because `can0` already exists as an embedded device.
+
+The instructions will be the same:
+
+```bash
+# ip link set can1 type can bitrate 500000
+# ip link set can1 up
+# ip link show can1
+ can0: <NOARP,UP,LOWER_UP,ECHO> mtu 16 qdisc pfifo_fast state UNKNOWN qlen 10
+ link/can
+ can state ERROR-ACTIVE (berr-counter tx 0 rx 0) restart-ms 0
+ bitrate 500000 sample-point 0.875
+ tq 125 prop-seg 6 phase-seg1 7 phase-seg2 2 sjw 1
+ sja1000: tseg1 1..16 tseg2 1..8 sjw 1..4 brp 1..64 brp-inc 1
+ clock 16000000
+```
+